RSA Selmer RL1 Ribbon Microphone 1947-1958

Wireless world Advert October 1946

Looking back from the 21st century it is hard to picture a ‘dream’ PA system as being 2 x 8” speakers attached to a 12 WATT amplifier with 2 mic inputs!! However, in the UK this marks the beginning of the age of amplified, modern popular music. Within a few years the wattage and power output of PA systems would be rising rapidly, trying to keep pace with bigger and louder guitar amps!

In 1947 R.S. Amplifiers Ltd was bought by H. Selmer & Co Ltd who were at that time the largest musical instrument manufacturer in England. RSA’s newly launched Truevoice U12 PA system (described in detail below) continued in production until 1958 and formed the starting point for the Selmer Truevoice range of amplifiers. Selmer amps soon became a firm favourite for a whole generation of guitarists and bands.

R.S.A Selmer U12 PA system
Photographs of U12 PA Courtesy of Mario Martins.
R.S.A Selmer U12 PA Amplifier
R.S.A Selmer U12 PA Speaker with Mic compartment.

The handy compartment lined with green baize is where the microphone would be stored in transit.

The RSA Selmer RL1 Microphone

R.S.A. Selmer RL1 Ribbon Microphone.

Designed as a gigging PA microphone the body of the R.L.1. is very solidly cast in aluminium. The styling is distinctive and unusual. Somewhere between Art Deco and Mock-Tudor!  I can’t think of another microphone like it. The design of the grill is also peculiar to this model (and the later RL2) with baffled slots cleverly contrived to prevent the direct implosion of breath on the ribbon.

Inside the R.L.1. the ribbon motor is also further protected by a cotton bag.

R.S.A. Selmer RL1 Ribbon Microphone Interior.
R.S.A. Selmer RL1 Ribbon Microphone Interior case.
R.S.A. Selmer RL1 Ribbon Microphone Grill Interior.
R.S.A. Selmer RL1 Ribbon Microphone Rear View..

Optional step-up transformer 15 Ohms – 50k Ohms (below)

 This enabled the mic to be plugged into a high impedance PA input or even a guitar amp.

R.S.A. Step-up Transformer 15 Ohms- 50k Ohms.

Performance.

In terms of performance the R.S.A. Selmer RL1 is pretty much what you would expect from a ribbon microphone designed to go with the U12 PA system. Although it is somewhat lacking in high end response this would not have been a problem when delivering through 2 x 8 inch speakers! However, it has a pleasing, warm midrange which is flattering for most vocalists.

I had been intending to record a vocal clip to illustrate the qualities of this microphone but current COVID-19 restrictions here in the UK still make it difficult to meet up with performers. Hopefully in the next few months this situation will improve and I will be able to add a suitable recording to complete this post. 

P.S.

Here are a couple of likely lads from Liverpool (circa 1960) with the Selmer RL2. The grill is identical to the RL1 but the bodywork is somewhat different. I wonder what ever happened to these fresh-faced youths?

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s